Lifeline Acrylic Interior Clear Wood Finish is a furniture grade clear coat for interior use. Lifeline Acrylic forms an attractive and durable protective film that adds sheen and makes cleaning wood surfaces a breeze. Available in Satin or Gloss options, it can be applied over Lifeline Interior, Prelude or directly on bare wood.
Product Type: Water-based acrylic formula
Uses: Highlighting interior log walls, cabinets, paneling, timbers, trim, railings and other vertical wood surfaces.
- Excellent UV protection
- Long-lasting color retention
- Breathable film allows unseasoned logs to dry out
- Will not yellow
- Low odor
- Makes wood walls easy to clean
- Seals out household odors and contaminants
- Spreads easily and evenly with a brush or airless sprayer
- Eliminates the worry about spills and watermarks
- Provides the toughness, clarity and durability of polyurethane and the application advantages of lacquer
- Easy soap and water clean up
- Contains no caustic dryers with dangerous, lingering odors
|1 Gallon||5 Gallon|
|1st Coat||350-450 square feet (bare wood)||1750-2250 square feet (bare wood)|
|2nd Coat||600-800 square feet(finished wood)||3000-4000 square feet (finished wood)|
|3rd Coat||700-900 square feet||3500-4500 square feet (finished wood)|
*Coverage will vary due the roughness and porosity of the wood surface.
Product Facts for Lifeline Acrylic Interior Clear Wood Finish
Clean Your Logs
Great Preparation is the Key to Application Success!
- Before you apply coatings to interior surfaces, always thoroughly wash them with a recommended cleaning solution.
- Mix two cups of Log Wash Wood Cleaner Concentrate with one gallon of warm water in a pail.
- Apply the Log Wash solution to the wall with a rag or sponge.
- Allow the solution to remain on the wall and wet for at least 10 minutes.
- Using a clean rag or sponge and a pail of clean water, wipe the Log Wash solution off of the surface.
- Frequently rinse the sponge or rag in the pail of water and frequently exchange the water in the pail with clean water.
Test the Stain
We always recommended performing a two coat sheen test to a clean, dry, bare area of the structure that you are planning on applying Lifeline Acrylic Interior Clear Wood Finish. Please Note: Lifeline Acrylic Interior Clear Wood Finish is difficult to remove once it has been applied. Before doing a full application, make sure that your sheen selection is correct and has the look you desire.
- Apply Lifeline Acrylic Interior Clear Wood Finish when temperatures are between 40° and 90° F.
- Avoid applying in direct sun
- Do not apply on surfaces that are hot to the touch
- Stir well before and during use
- Apply over completely dry Lifeline Interior products with a fine-bristle brush, an airless sprayer. Remember that Lifeline Acrylic Interior Clear Wood Finish is unlike paints and oil borne stains, a thin coat is best and most durable.
- Wait two hours. The first coat should be dry to the touch before applying any additional coats.
- Work area and equipment should be cleaned immediately with warm, soapy water. Rinse sprayers as per manufacturer’s directions. Allow equipment to dry thoroughly.
Note: If additional coats are needed to achieve the desired sheen, allow the first coat to dry completely before applying.
Store Lifeline Acrylic Interior Clear Wood Finish out of direct sunlight and protect from freezing. Although Lifeline Acrylic Interior Clear Wood Finish is freeze-thaw stable, if the product is accidentally frozen, allow to thaw and check for suitability of use before applying.
Lifeline Acrylic Interior Clear Wood Finish is shipped via FedEx ground and meets VOC compliance for all 50 states.
Lifeline Acrylic Interior Clear Wood Finish generally ships same day when ordered by 1pm EST.
Click here for this product’s Safety Data Sheets (SDS)